This is an old revision of the document!

https://www.ondrovo.com/a/20170107-stm8-getting-started/ https://stm8-binutils-gdb.sourceforge.io/

openocd

1. # sudo apt-get install automake libtool
2. # git clone git:repo.or.cz/openocd.git - # cd openocd - # ./bootstrap - # ./configure - # make - # sudo make install sdcc - Get sources from https://sourceforge.net/projects/sdcc/files/ - # sudo apt-get install libboost-dev gputils - # ./configure - # make - # sudo make install stm8-binutils - Get sources from https://sourceforge.net/projects/stm8-binutils-gdb/files/ - # ./patch_binutils.sh - # ./configure_binutils.sh - # cd binutils-2.3 - # make - # sudo make install stm8-flash - # git clone https://github.com/vdudouyt/stm8flash.git - # cd stm8flash/ - # make - # sudo cp stm8flash /usr/bin/ st-link permissions <code> # /etc/udev/rules.d/49-stlinkv2.rules # stm32 discovery boards, with onboard st/linkv2 # ie, STM32L, STM32F4. # STM32VL has st/linkv1, which is quite different SUBSYSTEMS==“usb”, ATTRS{idVendor}==“0483”, ATTRS{idProduct}==“3748”, \ MODE:=“0666”, \ SYMLINK+=“stlinkv2_%n” SUBSYSTEMS==“usb”, ATTRS{idVendor}==“0483”, ATTRS{idProduct}==“374b”, \ KERNEL!=“sd*”, KERNEL!=“sg*”, KERNEL!=“tty*”, SUBSYSTEM!=“bsg”, \ MODE:=“0666”, \ SYMLINK+=“stlinkv2_%n” SUBSYSTEMS==“usb”, ATTRS{idVendor}==“0483”, ATTRS{idProduct}==“374b”, \ KERNEL==“sd*”, MODE:=“0666”, \ SYMLINK+=“stlinkv2_disk” SUBSYSTEMS==“usb”, ATTRS{idVendor}==“0483”, ATTRS{idProduct}==“374b”, \ KERNEL==“sg*”, MODE:=“0666”, \ SYMLINK+=“stlinkv2_raw_scsi” SUBSYSTEMS==“usb”, ATTRS{idVendor}==“0483”, ATTRS{idProduct}==“374b”, \ SUBSYSTEM==“bsg”, MODE:=“0666”, \ SYMLINK+=“stlinkv2_block_scsi” SUBSYSTEMS==“usb”, ATTRS{idVendor}==“0483”, ATTRS{idProduct}==“374b”, \ KERNEL==“tty*”, MODE:=“0666”, \ SYMLINK+=“stlinkv2_console” # If you share your linux system with other users, or just don't like the # idea of write permission for everybody, you can replace MODE:=“0666” with # OWNER:=“yourusername” to create the device owned by you, or with # GROUP:=“somegroupname” and control access using standard unix groups. </code>